CHMJP - PARKS POLYURETHANE SATIN
- MSDS: CHMJP
- Manufacturer: PARKS CORP
- Product Name: PARKS POLYURETHANE SATIN
- National Stock Number: 8010-00F016768
Product Identification
Product ID:PARKS POLYURETHANE SATIN
MSDS Date:10/06/1995
FSC:8010
NIIN:00F016768
MSDS Number: CHMJP
Responsible Party
FALL RIVER, MA 02720-5000
US
Emergency Phone: 508-679-5938
Info Phone: 508-679-5938
Cage: 20450
Contractor
Telephone: (617) 679-5938
Cage: 20450
Ingredients
STODDARD SOLVENT (PETROLEUM DISTILLATE), MINERAL SPIRITS
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 50-55%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
ETHANOL (ETHYL ALCOHOL), TECSOL, ALCOHOL, SYNASOL *98-1*
CAS: 64-17-5
RTECS: KQ6300000
Fraction By Weight: 0-5%
OSHA PEL 1000 PPM
ACGIH TLV: 1000 PPM
SILICA, AMORPHOUS, PRECIPITATED AND GEL, SYNTHETIC
CAS: 112926-00-8
RTECS: VV7315000
Fraction By Weight: 3-8%
ACGIH TLV: 10 MG/CUM
<450 G/L
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES/SKIN: MILD IRRITATION.
PROLONGED/REPEATED EXPOSURE MAY CAUSE BURNING. ABSORPTION POSSIBLE.
INHALATION: IRRITATION TO NOSE/THROAT/RESPIRATORY TRACT. INGESTION:
SWALLOWING LARGE AMOUNTS MAY BE HARM FUL. NERVOUS SYSTEM
DEPRESSION. MATERIAL ENTERED INTO LUNGS ENTERED INTO LUNGS MAY
CAUSE INFLAMMATION/DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, STINGING, TEARING, REDNESS,
BURNING, DRYING/CRACKING OF SKIN, DIZZINESS, DROWSINESS, WEAKNESS,
FATIGUE, NAUSEA, HEADACHE, UNCONSCIOUSNESS, VOMITING, DIARRHEA,
INFLAMMATION
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN & LUNG DISORDERS.
First Aid
First Aid:EYES: FLUSH GENTLY W/WATER. SKIN: WASH W/SOAP & WATER.
INHALATION: MOVE INTO FRESH AIR. KEEP WARM & QUIET. GIVE ARTIFICIAL
RESPIRATION/OXYGEN IF NECESSARY. INGESTION: DON'T INDUCE VOMITING.
IF DROWSY/ UNCONSCIOUS, PLACE ON LEFT SIDE W/THE HEAD DOWN. DON'T
LEAVE UNATTENDED. OBTAIN MEDICAL ATTENTION IN ALL CASES.
Fire Fighting
Flash Point Method:TCC
Flash Point:78F
Lower Limits:1
Extinguishing Media:REGULAR FOAM, CO2/DRY CHEMICAL
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS W/A
FULL FACEPIECE OPERATED IN THE POSITIVE PRESSURE DEMAND MODE WHEN
FIGHTING FIRES.
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT. VAPORS ARE >AIR & MAY
TRAVEL ALONG THE GROUND/BE MOVED BY VENTILATION & IGNITED BY
IGNITION SOURCES DISTANT FROM MATERIAL HANDLING POINT.
Accidental Release
Spill Release Procedures:SMALL: ABSORB ON VERMICULITE/FLOOR
ABSORBENT/OTHER ABSORBENT. LARGE: ELIMINATE IGNITION SOURCES.
EVACUATE UNPROTECTED PERSONNEL. STOP LEAK AT SOURCE. PREVENT FROM
ENTERING DRAINS/SEWERS/STREAMS/OTHER BODIES OF WATER. PREVENT FROM
SPREADING. (SEE SUPP
Handling
Handling and Storage Precautions:STORE AWAY FROM ALL IGNITION SOURCES.
GROUND CONTAINERS WHEN POURING, LIMIT FREE FALL TO A FEW INCHES TO
PREVENT STATIC SPARKS.
Other Precautions:AVOID PROLONGED SKIN CONTACT. DON'T BREATH SPRAY
MIST. EMPTY CONTAINERS MAY RETAIN HAZARDOUS PROPERTIES. DON'T CUT,
PUNCTURE/WELD ON/NEAR THE CONTAINER. NEVER USE WELDING/CUTTING
TORCH ON/NEAR CONTAIN ERS, PRODUCT CAN IGNITE EXPLOSIVELY.
Exposure Controls
Respiratory Protection:USE SELF CONTAINED BREATHING APPARATUS FOR
CONCENTRATIONS >TLV LIMITS.
Ventilation:SUFFICIENT MECHANICAL GENERAL/LOCAL EXHAUST TO MAINTAIN
EXPOSURE BELOW TLV'S.
Protective Gloves:CHEMICAL RESISTANT
Eye Protection:CHEMICAL SPLASH GOGGLES
Other Protective Equipment:IMPERVIOUS CLOTHING & BOOTS
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
SPILL PROC CONT'D: IF RUNOFF OCCURS, PUMP/VACUUM TRANSFER PRODUCT TO
CLEAN CONTAINERS FOR RECOVERY. ABSORB UNRECOVERED PRODUCT. TRANSFER
CONTAMINATED ABSORBENT SOIL & OTHER MATERIALS TO CONTAINERS FOR
DISPOSAL.
Chemical Properties
Boiling Pt:B.P. Text:315-380F
Vapor Pres:2
Vapor Density:>1
Spec Gravity:0.902
Evaporation Rate & Reference:(ETHER=1): <1
Solubility in Water:<0.1
Appearance and Odor:BROWNISH/CLOUDY W/CHARACTERISTIC ODOR
Percent Volatiles by Volume:57.28
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT, PILOT LIGHTS, FLAMES & OTHER
IGNITION SOURCES
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE &
FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.